Comrod sectional lightweight masts are tripod sleeve masts suited for elevating headloads of up to 40kg* at heights of up to 24 metres. Tubes diameters of 48mm or 92mm are manufactured from either glass fibre epoxy or carbon fibre epoxy composite material depending on the mast height and headload weight and surface area. This composite material gives the mast a very high mechanical resistance and rigidity with reduced weight.
Guys are manufactured from polyester or aramid rope and are completely transparent to radio-electrical waves. A typical mast is supplied in two or three bags and can be deployed by two operators in approximately 20 minutes.
Click on the following link for a general description of Comrod ULM masts - General description of ULM mast series (pdf)
The following table contains a small selection of masts. If you have a specific mast requirement then please contact comrod sales (email@example.com) for further information.
|ULM Ultra-Lightweight Tripod Sleeve Mast, 15m (pdf)||15||20||ULM-C 48/15-1.3||ULM|
|ULM Vertical Sleeve Mast, 10m (pdf)||10||40||ULM-C 92/10-1.5||ULM-LOS|
|ULM Vertical Sleeve Mast, 20m (pdf)||20||40||ULM-C 92/20-1.5||ULM-LOS|
|ULM Vertical Sleeve Mast, 24m (pdf)||24||40||ULM-C 92/24-1.5||ULM-LOS|
|ULM Vertical Sleeve Mast, 10m (pdf)||10||40||ULM-G 92/10-1.5||ULM-VR|
|ULM Vertical Sleeve Mast, 15m (pdf)||15||30||ULM-G 92/15-1.5||ULM-VR|
|ULM Vertical Sleeve Mast, 17m (pdf)||17||30||ULM-G 92/17-1.5||ULM-VR|
|ULM Vertical Sleeve Mast, 20m (pdf)||20||20||ULM-G 92/20-1.5||ULM-VR|
|Light tripod for line of sight headloads (pdf)||1.9||30||Tripod|
|Flange for V-Ring - Top load interface|
* Maximum top load dependant on wind surface area.